RunRyder RC
WATCH
 1 page 456 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › to glue or not to glue?
04-26-2010 06:04 AM  8 years agoPost 1
truonk

rrNovice

sugar land, tx 77498

My Posts: All  Forum  Topic

I've got a hatori SB-19 or 20 for the os 91 hz and was wondering if I should glue the fuel/ exhaust nipple with jb weld? I have mine just tighten down at the moment and afraid it might come loose. I had never glued my mp5 sb either and haven’t ran into any troubles yet. How would i properly glue it if i have to? Thanks for the tips in advance.

PM  EMAIL  Attn:RR  Quote
04-26-2010 06:57 AM  8 years agoPost 2
Aaron29

rrProfessor

USA

My Posts: All  Forum  Topic

I did this and never thought twice. I recommend it.

Mix JB weld, goob it on the nipple's threads liberally, install nipple. Using my finger, I make a nice little fillet around the nipple's nut (can I say that in public?) to ensure a good seal. Clean excess off with a paper towel. You should end up only being able to see a tiny amount of JB beneath and around the nut of the nipple for a nice appearance.

Let dry 24 hours. Fly.

Never had any problems with mine.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 456 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › to glue or not to glue?
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Friday, August 17 - 4:57 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online