RunRyder RC
WATCH
 1 page 2159 views Post Reply
Home✈️Aircraft🚁HelicopterAlignT-REX 700N › Clutch liner for a Trex 700?
04-05-2010 02:04 AM  10 years ago
Topic Vote0Post 1
SCC

rrApprentice

Mobile, Al. USA

MyPosts All Forum Topic
Clutch liner for a Trex 700?
How do you replace a clutch liner for a Trex 700?
SHARE  PM  EMAIL  Attn:RR  Quote
04-05-2010 02:11 AM  10 years ago
z11355

rrMaster

New England

MyPosts All Forum Topic
generally you soak the bell in acetone overnight and the liner will fall out in the morning. clean up any excess, cut the new liner to correct length (dry fit it), wrap a single or double wrap of electrical tape around the clutch itself, smear a very thin coat of 30 minute epoxy around the inside of the bell, install the liner, shove the clutch in
and let it all dry. remove clutch & tape and reassemble.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-05-2010 03:04 AM  10 years ago
VinceY

rrApprentice

Newnan GA

MyPosts All Forum Topic
Ditto, perfect everytime. The clutch will engage sooner with the new liner, there's a large gap on the stock liner.Team Synergy/ Rail Blades
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-05-2010 05:07 AM  10 years ago
jschenck

rrProfessor

La Vista, NE.

MyPosts All Forum Topic
I'll add that I put the starter shaft in the clutch to make sure the clutch is centered while the glue sets. I usually can get the old liner out with new #11 blade and some care. If you soak it in acetone you might want to put some tape over the bearing so it won't get dried out (?! - not sure if that's a big deal) or at least push a little grease in it after word. Not too much, don't want have it sling out into the liner while running.

I put a Raptor-90 liner in my 700 this winter. The R90 Liner is too short so I ended up putting in an additional smaller chunk to finish it off. Works well, a little over a gallon so far since the weather warmed up here and it's seems to "run right"
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 2159 views Post Reply
Home✈️Aircraft🚁HelicopterAlignT-REX 700N › Clutch liner for a Trex 700?
Print TOPIC

 2  Topic Subscribe

Friday, October 23 - 9:57 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online