RunRyder RC
WATCH
 1 page 551 views Post Reply
03-31-2010 02:31 AM  10 years ago
Topic Vote0Post 1
rkeith2

rrVeteran

Norco, CA

MyPosts All Forum Topic
YS 91 SR
Looking for the recommended settings after break in.

It seems to still be quite fat and the tail kicks at hover.

Dont want to ruin it as I have seen a couple that sounded ok and then burned up being too lean.

Maybe the best temperature and where to measure it at would be a safe approach.

SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-31-2010 02:39 AM  10 years ago
george0079

rrElite Veteran

USA

MyPosts All Forum Topic
I keep mine between 180 and 195, measured at the base of the head, where it meets the caseHell... I can fix that.
Uh oh..
Nope.
It's ***ked!!!
RE-KIT!!!!!
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
03-31-2010 02:55 AM  10 years ago
whyfly

rrVeteran

Temecula C.A.

MyPosts All Forum Topic
low 3/4 mid 1.50 or 54 clicks n high is 1 out or 26 clicks out this is sea level.

my pipe is sb 19 with those setting.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-31-2010 03:07 AM  10 years ago
rkeith2

rrVeteran

Norco, CA

MyPosts All Forum Topic
Thx

I just read thru your posts and made the changes and will measure temps this weekend.

SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-31-2010 03:26 PM  10 years ago
nofear

rrApprentice

Chicago - NW Suburbs, IL

MyPosts All Forum Topic
Not sure where I am on the needles, but I shoot for smooth transitions between idle, mid and high and aim for about 190-200 just below the head on the back of the motor once i have landed and stopped the blades.

I like to run on the phat side a bit.

IMO, it makes so much power at factory settings there is no need to run the SR on the ragged edge.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
03-31-2010 03:35 PM  10 years ago
puma1824

rrVeteran

Maryland, USA

MyPosts All Forum Topic
Maybe try Todd Bennetts suggested settings:

http://freestyle3d.com/site/ys-90-sr/
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 551 views Post Reply
Print TOPIC

 2  Topic Subscribe

Monday, October 26 - 7:25 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online