RunRyder RC
WATCH
 1 page 643 views POST REPLY
HomeAircraftHelicopterFlybarless Rotor Head SystemsAlign 3G › / 700N tail setup
02-02-2010 03:38 AM  8 years agoPost 1
wings19

rrKey Veteran

Tucson, AZ

My Posts: All  Forum  Topic

So I have the rudder servo ball at 10mm like the manual states. I am not getting full travel of the tail blades though. Anyone else having this issue? Radio is set to 100% endpoints.

Another question is this... I am used to setting up the tail so the tail rotor control arm (the one under the tail gear box) is 90 degrees to the tail output shaft. This leads to a slight pitch in the tail blades to counter torque. When I set up the 3G tail it seems to like the tail blades at 0 pitch in the center. Is that right? It makes the gyro work harder that way it seems.

Nick
If the wings are traveling faster than the fuselage, it's probably a helicopter

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 643 views POST REPLY
HomeAircraftHelicopterFlybarless Rotor Head SystemsAlign 3G › / 700N tail setup
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Sunday, July 22 - 12:06 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online