Northern Ireland U.K
My Posts: All Forum Topic
No problem there shlm.
The one way bearing in the center of the clutch is 10 mm outside diameter and its 11.80 mm long. The shaft size in the center it takes is 6 mm diameter. This is the info that is stamped into the one way bearing that i read off it. It says Germany, HF 0612, INA, WX. I dont know what any of this means but a bearing dealer will. I change mine when they start to slip. I turned out a suitable drift on one of my smaller lathes so i can press the old one out and the new one in. Hope this bit of info helps.
If it doesnt move and its meant too... use WD 40. If it moves and its not meant too...use duct tape!