RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 881 views POST REPLY
HomeAircraftHelicopter
e-
Blade
Blade MSR › Tail Boom Assembly w/Tail Motor/Rotor/Mount: EFLH3002
01-23-2010 05:35 PM  8 years agoPost 1
gbagley

rrNovice

Metairie, Louisiana

My Posts: All  Forum  Topic

Tail Boom Assembly w/Tail Motor/Rotor/Mount: EFLH3002

So far I have replaced this part twice. After two different crashes the end cap pops off. Very poor design. Has anyone else had this problem? From the looks they are back ordered everywhere. Also, its not the cheapest item to replace either. Has anyone figured out a mod to stop this from happening?

Thanks

PM  EMAIL  GALLERY  Attn:RR  Quote
01-23-2010 06:25 PM  8 years agoPost 2
jamlizzard

rrNovice

Harrison,Ohio

My Posts: All  Forum  Topic

msr
I saw a video on youtube where a guy used self fusing tape to wrap the tail motor. This looked like a good idea to me although i haven't been able to find this tape.

PM  EMAIL  Attn:RR  Quote
01-24-2010 01:05 AM  8 years agoPost 3
skeppley

rrVeteran

Auburn PA

My Posts: All  Forum  Topic

You can put heat shrink over the end of the motor.
All the new versions have a cap epoxied on so you dont have to worry about it.

'Experience is a hard teacher because she gives the test first, the lesson afterward.'

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 881 views POST REPLY
HomeAircraftHelicopter
e-
Blade
Blade MSR › Tail Boom Assembly w/Tail Motor/Rotor/Mount: EFLH3002
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Sunday, June 24 - 2:57 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online