RunRyder RC
WATCH
 1 page 2880 views POST REPLY
HomeAircraftHelicopter
e-
Kontronik Electric Components
› Help me to program Kontronik jive 100+ lv
01-14-2010 10:21 AM  8 years agoPost 1
telix636

rrApprentice

Italy-Novara

My Posts: All  Forum  Topic

HI At All,
I've Buyed a Kontronik Jive 100 + Lv to use on my logo 500 3D but Redeang the instruction I'm not sure how Program it!!!!

Please can help me....
I want to use in with 6s lipo , governor mode.

There's 2 tipe of hely setting the 4 and the 11 (Heli 1 and Heli 2) what is the difference?
Is better buy the program card II?

TKS
MArco

PM  EMAIL  Attn:RR  Quote
01-14-2010 11:45 AM  8 years agoPost 2
clayboy

rrApprentice

phuket thailand

My Posts: All  Forum  Topic

if u use mode 4 the govener set upp for a constant ish fight time, if u hav a bad 5000 6s and a good 5000 6s u will end up with pretty much same flight time do the better 1 will have more head speed, and if u land disconnect battery and start again u will have lower head speed do it detects that battery is weaker. mode 11 is constant head speed , if u set up mode 11 the first spool up will b the master so make sure u have a fully charged battery

no need for prog card2 unless u want to change bec vol but default 5,6 is perfect for most people.

prog card1 if u want to change spool up time and lvc setting

it is good to set the end points in the radio after programming

have a linier throttle curv, put low atv for throttle at 50% and stick all the way down , plug in battery, now nothing would happen , scroll down atv until jive arm
then a few more click for safety, with a spektrum or jr u should b @ 83% or so.put same numbers on high atv, now u will read correct throttle % in radio

i started with nothing and still got most of it left

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
01-14-2010 11:53 AM  8 years agoPost 3
telix636

rrApprentice

Italy-Novara

My Posts: All  Forum  Topic

Ok, I think to use mode 11.

I put gas stick at low , radio on.
Put jumper on esc , conect battery, aft beep leave the jumper... wait 11 tones and rise the gas stick tu full... disconect the battery.
is correct? (or I had to rise down the gas stick and aft disconect the battery?)

For tipe of battery is lipo presetted? using full charged battery the esc know how many cell are conected right? (in this case how value is presetted for low voltage at each cell's?)

This is onle opertaion that I had to do?

For arming if at low stick doesn't arm I rise down the atv of gas chanel.... correct? and left atv full throttle alt 100 ...

I use futaba T10C
TKS
MArco

PM  EMAIL  Attn:RR  Quote
01-14-2010 12:22 PM  8 years agoPost 4
clayboy

rrApprentice

phuket thailand

My Posts: All  Forum  Topic

u have to set mode 9 for lipo , think 2.9v is the lvc, and cut off, if u want to change to slow down u need a prog card 1. if u adjust atv for throttle u should have same at low and high,

i do not know how it works with futaba but on spektrum it arm @ 83% so in reality if u not adjust your end points and set throttle to 80% u will have 97% in reality if it make sense. it is not a problem if u know about it just lower the % on the throttle to desired head speed but if u want correct % in the radio u have to adjust your atv.

i started with nothing and still got most of it left

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
01-14-2010 09:56 PM  8 years agoPost 5
telix636

rrApprentice

Italy-Novara

My Posts: All  Forum  Topic

But using mode 11, if I do the spool up with a idle up 1 for exp with throtle curve at 60% (Ex. 1900 rpm) and the esc store this, and in the secondo flight or during flight I use idle up 2 (80% throttle curve ex 2100 rpm) how happens? the rpm doesn't increase?
TKS
MArco

PM  EMAIL  Attn:RR  Quote
01-17-2010 07:29 PM  8 years agoPost 6
MrMel

rrProfessor

Gotland

My Posts: All  Forum  Topic

Yes it increases, it just remember 1900 for 60%, so each time you put in 60% it will be 1900...

80% will be whatever it will be (2100 or something, but it will always be that when you run 80%)

Gone fishing..or hunting..or something
My site: http://heli.dacsa.net - VBar videos and more

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 2880 views POST REPLY
HomeAircraftHelicopter
e-
Kontronik Electric Components
› Help me to program Kontronik jive 100+ lv
 Print TOPIC  Make Suggestion 

 4  Topic Subscribe

Wednesday, July 18 - 3:54 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online