RunRyder RC
 1  Topic Subscribe
 1 page 388 views POST REPLY
10-20-2009 03:08 AM  8 years agoPost 1


Michigan USA

My Posts: All  Forum  Topic

I have a Venture 50 (don't laugh) and the weakness is the blade grips. There is some bloody slop in the the blade grips that I couldn't fix, so I downloaded the Pantera 50 manual and the first thing that I saw was that the the dampers are the same size as the venture ones, so I took the risk by buying a set of the hard dampers. I also bought the nice and big Pantera 50 blade grips, 6mm spindle shaft, and all the bearings too.

I was right. I had no trouble installing them into the Venture yoke, so now the grips have NO slop anymore. The trouble with the venture grips is that both bearings go in one side and so the grips is not supported very well, but on the Pantera, one bearing goes in one side of the grip and one on the other side, so the grip is better supported.

Now I'll do the next test and get the Pantera Hiller Control Lever Assembly, Seesaw, so I can fit the 4mm flybar.

I should a good heli then eh???

 1 page 388 views POST REPLY
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, June 23 - 1:24 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online