DX7 help needed here

rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 419 ONLINE 1 EVENTS SEARCH REGISTER START HERE

WATCH

1 page 531 views

Post Reply

RunRyder	RunRyder

Home › RC & Power › ✈️Aircraft › 🚁Helicopter › Radio - Spektrum DSM › DX7 help needed here

09-15-2009 01:31 AM 11 years ago

Topic Vote

0Post 1

flynbryan

rrApprentice

Long Island N.Y.

MyPosts All Forum Topic

DX7 help needed here

I have a Spektrum DX7 W/ar6100 in my trex 450 and the ar7000 in my bell47g2. when I turn the transmitter on then plug in the battery. Sometimes the reciever doesn't bind right away. When the gy401 initializes and the reciever binds afterwards, the gyro flashes. If the reciever binds before the gyro, the gyro initializes as normal In AVCS. Both my machines have this problem. Is it just a matter of rebinding?

SHARE PM EMAIL GALLERY Attn:RR Quote

09-15-2009 02:12 AM 11 years ago

0Post 2

JAYHELI

rrApprentice

Northeast Pennsylvania

MyPosts All Forum Topic

I would rebind the receiver to the transmitter. make sure everything is neutral mainly the rudder. your failsafe position may be off. spektrum reccomends rebindind after setup

SHARE PM EMAIL GALLERY Attn:RR Quote

09-15-2009 03:04 AM 11 years ago

0Post 3

shizack

rrKey Veteran

Aiken, SC USA

MyPosts All Forum Topic

Yes - rebind after setup. Make sure you have your tx gyro switch in the "HH" position when you rebind because the 401 initializes quickly - sometimes faster than the rx. This makes sure that when you're about to fly if the gyro initializes first, it'll be in HH.A soul in tension is learning to fly

SHARE PM EMAIL HOMEPAGE Attn:RR Quote

09-15-2009 11:13 AM 11 years ago

0Post 4

flynbryan

rrApprentice

Long Island N.Y.

MyPosts All Forum Topic

Would you normally rebind after everytime you do a setup. Tell me more about failsafe position, I never set it up.

SHARE PM EMAIL GALLERY Attn:RR Quote

09-15-2009 12:05 PM 11 years ago

0Post 5

flynbryan