RunRyder RC
WATCH
 1 page 619 views Post Reply
Home✈️Aircraft🚁Helicoptere-BladeBlade 400 › 3D Swash set up?
06-15-2009 12:03 PM  11 years ago
Topic Vote0Post 1
68eb429

rrNovice

Tiverton, RI 02878

MyPosts All Forum Topic
3D Swash set up?
Ok so as im Learning "repairing" my new found addiction gathering assorted tools etc etc. I found the measurement for stock servo rod length to swash plate well go figure they were not the same or did they make it level....I removed head, put swash plate gauge on, unplugged two motor wires, turned tx on, plugged in battery, then brought the collective up to half throttle(mid point).Now the port and starboard are low and the nose is high.. my question is do I bring the nose down? or do i bring the port and starboard up. I also did the blade grip mod as well to the head.. more because i had repaired that much... as well as i read it was easier on the servos(Option 4: Blade Grips Flipped (Leading Edge Control). Mixer Arms Flipped, long side of mixer arm to Flybar/SeaSaw and short side of mixer arm to swash) Any input would be great Thanks Nate
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 619 views Post Reply
Home✈️Aircraft🚁Helicoptere-BladeBlade 400 › 3D Swash set up?
Print TOPIC

 1  Topic Subscribe

Wednesday, January 27 - 1:25 pm - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online