RunRyder RC
WATCH
 1 page 1625 views TOPIC CLOSED
04-24-2009 05:40 AM  10 years ago
Topic Vote0Post 1
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

MyPosts All Forum Topic
Axe CP help needed
Hello, My son purchased a used Axe cp, It did not come with a receiver so we are using a 7 ch futaba receiver for now. I was able to find a wire schematic on line, the servos seem to be working properly, It is ccpm. The problem is the tail rotor runs all the time when it is plugged in. Also while the tail is plugged in the main rotor will not work. Unplug the tail rotor & the main rotor will spool up when given the correct input to spool up. When I have the tail plugged in I have to give the rotor a little help to move, then it seems to go full speed until I unplug it. Ive read about initalizing the tail rotor, right stick, beeps, left stick, beeps. Im not getting any beeps at all. Does anyone have any ideas?
SHARE  PM  EMAIL  GALLERY  Attn:RR
04-25-2009 12:52 AM  10 years ago
jag8864

rrNovice

calif

MyPosts All Forum Topic
HElp For AXE CPl
HEY there The frist thing to check is the eboeard then the connections the problem will be in the reciver if the eboard is okay there is One orange wire that controls the tail that wire should be plugged into the 3rd port from the bottom of the reciver make sure that you have a good connection if it is the wrong place you will have the problems that you have stated hope this helps
Jag8864
SHARE  PM  EMAIL  Attn:RR
04-25-2009 01:39 AM  10 years ago
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

MyPosts All Forum Topic
Thanks for the help I will check it out.
SHARE  PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 1625 views TOPIC CLOSED
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Thursday, August 22 - 6:42 pm - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online