RunRyder RC
WATCH
 1 page 550 views POST REPLY
Home✈️Aircraft🚁HelicopterAlignT-REX 600N › servos not as smooth with helicommand??
04-23-2009 01:29 AM  10 years ago
Topic Vote0Post 1
volitan

rrNovice

ottawa ontario canada

MyPosts All Forum Topic
servos not as smooth with helicommand??
I just installed my helicommand and I noticed that all my servos kinda jerks a little and its not as a smooth travel with the helicommand compared to what it was before.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-23-2009 01:46 AM  10 years ago
WreckRman2

rrKey Veteran

Orlando, FL

MyPosts All Forum Topic
You need to turn the gain down in the Heli Command software.________________
David Smith
407.937.9556
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-23-2009 01:48 AM  10 years ago
volitan

rrNovice

ottawa ontario canada

MyPosts All Forum Topic
what would be the recommended start gain?

And in what section of the software do i do this?

Thanks alot
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-23-2009 01:51 AM  10 years ago
volitan

rrNovice

ottawa ontario canada

MyPosts All Forum Topic
just found this too!

• Servo movements appear in step-like increments!
There are two possible causes:

1. (problem-free):
Some RC-equipment provide servo pulses with quite slow frame rate. This may apply with 2.4 GHz equipment. If servo movements appear in steps or stuttering, they show exactly those positions which actually have been transmitted, and quantisized in the same time period steps as they have been received. Since the HeliCommand drives the servos faster than the RC receiver alone, the servos may clearly show this quantisation. Without HeliCommand the servos accelerate slightly slower and therefore smoothen the steps naturally.
There is no effect on the control behaviour in flight; therefore this phenomenon has no relevance for the control.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
04-23-2009 02:16 AM  10 years ago
WreckRman2

rrKey Veteran

Orlando, FL

MyPosts All Forum Topic
Go to the hor + pos tab.

Under Horizontal and Position mode

lower the total sensor gain
lower the stick sensivity gain
________________
David Smith
407.937.9556
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-23-2009 02:20 AM  10 years ago
volitan

rrNovice

ottawa ontario canada

MyPosts All Forum Topic
thank you sir!
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 550 views POST REPLY
Home✈️Aircraft🚁HelicopterAlignT-REX 600N › servos not as smooth with helicommand??
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Wednesday, September 18 - 7:25 pm - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online