RunRyder RC
 1 page 617 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › ATGv3/T9CHP set up
12-26-2008 11:16 PM  9 years agoPost 1


Canyon Country Ca

My Posts: All  Forum  Topic

Can any one send me some info. on the set up of the Curtis Youngblood ATGv3 and a T9CHP Futaba tx. I must have something wrong .I have a 600n, the first time I ran it up it was normal until I got to half throttle and it started to oscillate between full and low throttle.If any one can help I would really appriciate it.Thanks so much, Brian:

PM  EMAIL  Attn:RR  Quote
12-27-2008 12:33 AM  9 years agoPost 2
v58 fuy


UK - Kent

My Posts: All  Forum  Topic


I have run the ATG v3 on 2 600N and now on a Vibe, the setup on the 9CHP is fairly straight forward if you follow the manual and the few points below:

1) Make sure your throttle curve is a straight line 0,25,50,75,100 in all throttle modes i.e. idle-up 1 and 2.

2) Make sure REVO is set to INH i.e. disabled in the radio

3) Go into the Governor function on the radio, I select switch C which is a 3 position and enables me to have the governor off, and 2 selectable headspeeds.

4) In the governor menu set the rate-up to 50%, Centre to 75% and Down to 80%, then scroll to the bottom of the screen and it will go to a second page - here you must change MIX to ACT.

5) When you setup the ATG and get to the headspeed part, select the governor screen on the radio, move switch C to centre position and adjust the 75% (in 4 above to a headspeed for idle-up 1), then move switch C to down, and adjust the 80% (in 4 above to a headspeed for idle-up 2).

6) By keeping the rate-up on switch C to 50% (governor off) this means the governor will not come on until you move switch to either centre position or down position, at which point it will give you the headspeed you want.

Once you done the above setup simply setup your throttle curve as normal.

Hope this helps,


12-27-2008 12:46 AM  9 years agoPost 3

rrElite Veteran

North Carolina

My Posts: All  Forum  Topic

wondering if your problem is similar to the one I had.

Man, I miss the eighties.

 1 page 617 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › ATGv3/T9CHP set up
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, July 19 - 3:29 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online