Thanks a mill
did not make much sense, but helped me google more english version of the steps ;-)
this worked for me and now i got 100% pos negative.. whoohooo!!
Thanks again speed nut!http://www.runryder.com/t474491p1/
Thanks, billrad, that was what I needed. My throttle stick makes use of the full range now.
It's kind of odd to get into. Here's my steps:
Ensure the Aileron D/R switch is in the UP position.
Press and hold the DOWN and SELECT buttons and turn on radio. Now you're in the setup menu.
Scroll up/down until you get to the screen that says [Model Reset]
Press the Adjust Descrease button (r/h side of LCD)
Flip the Aileron D/R switch down
Press the Adjust Increase button
Flip the Aileron D/R switch up
Press the Adjust Descrease button
Keep alternating this Aileron D/Rup/down and Adjust Increase/Decrease sequence (about 5 cycles as Hilgert said)
The radio will 'beep' and the LCD will go dark. This is the LCD test.
Scroll Up/Down (left side of LCD screen) through the Service Menu (at your own risk)
Spektrum DX7 stick centering.
For the last year, I've been living with a throttle "center stick" position that was about one bar width above the index on the gimbal. This has always annoyed me and it was inconvenient when it came time to level a helicopter swashplate.
With the use of the instructions provided on the first post in this topic and a little fiddling, I managed to reset the stick center position and end point adjustments.
On the Stick Center? page, center all the sticks and let go! Press the CLEAR button.
On the next page (it lists 3 hexadecimal values for each of ST1, ST2, ST3 and ST4). Use the select button to select an axis. Ex: Throttle is ST3. Move the throttle to full up position, press CLEAR. Move the throttle to full down, press CLEAR. Repeat for each axis.
Now your center points and end points are calibrated!
When you are done, go to the All Settings OK? page and press CLEAR.