RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 348 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › 611 Gyro... LmtA & B... and EndPoint
03-08-2008 06:52 AM  10 years agoPost 1
SpottedCow

rrApprentice

Whetstone, Arizona

My Posts: All  Forum  Topic

Thought I would review my 611 setup... something I noticed.. and wondered if it was wrong..

When in the LmtA or LmtB menu I have the settings at 125% which allow me full tail movement without binding. My radio (RD6000) is set at 100% EndPoint for left and right stick. While in this menu I move my stick left or right and the servo stops about 10 degrees before the rudder stick is at full deflection. If I set my EndPoints down to about 70 I get full deflection with servo movement.

Question is... should I set the radio endpoints at 100.. or 70? since I fly in AVC mode.. does this realy matter... I thought I read somewhere on here that the EndPoint settings controlled the piro rate.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-08-2008 06:56 AM  10 years agoPost 2
MrMel

rrProfessor

Gotland

My Posts: All  Forum  Topic

Endpoints only change piro rate, leave it at 100, if you want faster piro when you fly, raise it, if you want slower, lower it.

You cant "test" the piro rate on the bench, its not until the heli is flying you could see how much deflection you get (when the gyro is working for full)

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 348 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › 611 Gyro... LmtA & B... and EndPoint
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Saturday, June 23 - 12:07 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online