RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 544 views POST REPLY
HomeAircraftHelicopterSynergy R/COther › Servo Horn Mount
03-07-2008 08:22 PM  10 years agoPost 1
shuglu

rrApprentice

Melbourne

My Posts: All  Forum  Topic

Just bought an N9 with only three tanks through it and giving it the once over before I take her up. I've gone through every step of the build and double checked everything. Read most of the posts here to learn what I can. I can't figure out one thing though. Should the servo horn mounts (110-228/9) but up against the cyclic servo pivot supports (110-217) with no play at all, so that the shoulder of the servo horn mounts sits against the bearing?

PM  EMAIL  GALLERY  Attn:RR  Quote
03-07-2008 09:01 PM  10 years agoPost 2
RyanW

rrKey Veteran

Edmond, Oklahoma

My Posts: All  Forum  Topic

Depending upon which servos and horns you use, the height will differ. On the outside servos I had to put spacers under the G-10 straps that hold hold the flange bearing. I spaced it so you can barely see light between the bearing and brass standoff/servo screw. On the middle servo there is more space between the two, but it still functions properly.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-11-2008 04:53 PM  10 years agoPost 3
airboss

rrElite Veteran

OC ,california

My Posts: All  Forum  Topic

leave sme space between yor servo horn and the bearing support. this will allow it to move freely, I used spare srvo horn ends for spacers and drilled them to fit.

Urukay HPS3 KSE 700 HPS3

PM  EMAIL  GALLERY  Attn:RR  Quote
03-12-2008 08:19 PM  10 years agoPost 4
shuglu

rrApprentice

Melbourne

My Posts: All  Forum  Topic

Cheers guys

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 544 views POST REPLY
HomeAircraftHelicopterSynergy R/COther › Servo Horn Mount
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, June 23 - 11:00 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online