RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 425 views POST REPLY
HomeAircraftHelicopterThunder TigerRAPTOR 90 › Quick UK head question
03-07-2008 04:24 AM  10 years agoPost 1
FenderBean

rrElite Veteran

Fort Hood TX

My Posts: All  Forum  Topic

I was wondering about the top seesaw where the head button screws into. On each side there are 3 holes, 2 on one side and at the other end just 1. I know its for the upper mixer arms but if I try and us the outer hole on the 2 hole side the ball link hits the edge of the flybar cage. The instructions say use the outer hole unless your going to hard 3D then us the inner one. Am i using the right hole? or should I flip it over and use the side with just the one hole. Hope you guys can understand what I am saying, lots of hole talk

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-07-2008 04:39 AM  10 years agoPost 2
FenderBean

rrElite Veteran

Fort Hood TX

My Posts: All  Forum  Topic

i think i found the problem, after looking at a few pics of other heads I noticed they have there mixing arm in the side with one hole and the 2 holes are on the other end
Quk needs instructions with there heads = )

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-07-2008 06:04 AM  10 years agoPost 3
kirk

rrVeteran

Northern, Colorado

My Posts: All  Forum  Topic

If your doing hard 3D the inner hole on the side that has two holes will give you the fastest response...

Kirk

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 425 views POST REPLY
HomeAircraftHelicopterThunder TigerRAPTOR 90 › Quick UK head question
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, June 19 - 11:44 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online