RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 1900 views POST REPLY
HomeAircraftHelicopter
e-
JR-Heli
Other › voyager rebirth - but I need some help
03-06-2008 05:10 AM  10 years agoPost 1
tdr1919

rrNovice

coram, NY USA

My Posts: All  Forum  Topic

Pulled out the VE after 2 years (brushed motor controller was toast) and fitted it with an old AXI 22/30/3 I had in my parts box. I modified a 20 tooth car pinion and I was back in business. I have a GY240 gyro & a 4S 2070 lipo. I have a head speed of 1800 rpm. the hover is smooth but my problem is I have to keep constant right stick (rotor) to keep the nose straight, I can pretty much zero it out with the trim, but I would like to get it setup properly.
Thanks,
Tom

PM  EMAIL  Attn:RR  Quote
03-15-2008 05:22 AM  10 years agoPost 2
mlmcquiggjr

rrApprentice

Tulsa, OK

My Posts: All  Forum  Topic

Extra Rudder
The change of the motor probably needs a bit more rudder to offset the difference in power output. If you had used the same motor the rudder would have been fine. I would lengthen or shorten the pushrod to the servo to add the needed throw to stop the tail.

PM  EMAIL  GALLERY  Attn:RR  Quote
03-23-2008 03:20 PM  10 years agoPost 3
rcexpress123

rrNovice

north babylon ny

My Posts: All  Forum  Topic

you have a gy240 gyro it should hold the tail in one spot unless you tell it too move check you setting on the gyro sound like the head hold not doing it job..You might need too ajust the gain on the gyro..One ? for yea did you turn off the rev mix ?

i hope this heli some

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1900 views POST REPLY
HomeAircraftHelicopter
e-
JR-Heli
Other › voyager rebirth - but I need some help
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, June 21 - 9:26 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online