RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 398 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › Having trouble with jr scan select 790
03-06-2008 02:15 AM  10 years agoPost 1
RPMATLANTA

rrApprentice

Cumming GA

My Posts: All  Forum  Topic

I have followed the instructions and my receiver doesnt seem willing to lock on to my 9303. The led just keeps blinking slowly? Any suggestions would be appreciated!

Team Horizon Pilot
Take offs are optional! Landings are not!

PM  EMAIL  GALLERY  Attn:RR  Quote
03-06-2008 09:32 AM  10 years agoPost 2
9387ASH

rrElite Veteran

UK

My Posts: All  Forum  Topic

The typical problems I have come across on these synth systems is...

The Synth Module being set to a non- legal channel (No RF is generated)

The Tx is set to the wrong modulation ( so easy to do !! )

You press the button for the 2nd time too late. I press until the blue light goes out, release then press again almost immediately.

Receiver too far away from Tx antenna.

Rx Battery voltage too low.

If all the above "operator errors" aren't valid, then the receiver is probably a duff one (unfortunately it happens).

PM  EMAIL  Attn:RR  Quote
03-06-2008 11:07 AM  10 years agoPost 3
RPMATLANTA

rrApprentice

Cumming GA

My Posts: All  Forum  Topic

Thanks Mac Man
I will try being faster with the scan button sequence! I have had this receiver for over a year on a helicopter using a 6102 that has channel 30, I decided to put it on my 9303 that is on channel 60. Even though I have tried to match it to the 9303 its still working on the 6102. Thanks again!

Team Horizon Pilot
Take offs are optional! Landings are not!

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 398 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › Having trouble with jr scan select 790
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Sunday, June 24 - 12:11 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online