RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 440 views POST REPLY
03-05-2008 07:05 PM  10 years agoPost 1
BonesMalone

rrNovice

East Midlands

My Posts: All  Forum  Topic

Fitted the CNC cooling fan with one way bearing into my hawk, after puuting it all back together i noticed that the top of fan is rubbing on the underside of the upper fan duct, has anyone else had this problem ???/

I could slide the whole engine assy down a little but that would then men the clutch gear would not be in full mesh with the main gear....

Any thoughts ????

Tony

PM  EMAIL  GALLERY  Attn:RR  Quote
03-05-2008 07:14 PM  10 years agoPost 2
Gearhead

rrMaster

Vt

My Posts: All  Forum  Topic

edited,,
that fan should mount the same as the stock fan mounts, if you can't push the engine up some, then it sounds like you have the engine mount mounted upside down on the engine..

Jim
Buzz Buzz Buzz

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 440 views POST REPLY
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, June 19 - 11:44 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online