RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 347 views TOPIC CLOSED
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › GV1 setup on trex nitro
03-05-2008 06:36 AM  10 years agoPost 1
Helijockey

rrKey Veteran

150 miles from somewhere

My Posts: All  Forum  Topic

When I fly my trex I notice that the heli doesn't lift off like it should in idleup at 2000 HS and +/-12 pitch I've checked the engine and I can keep my finger on the backplate for about 5 seconds. Once the heli is in the air the Gv1 works fine but I'm scared if I do a flip etc at take off the bird will crash. With the GV1 off I've checked and the engine runs fine. Perhaps my throttle curve is not set properly while doing the idle limit? My throttle curve in normal mode is 16.21.30.40.50.60.70 but when I'm setting the idle limit I increase the high point from 70 to 100. I'd appreciate if u guys could tell me what I'm doing wrong, thanks!

PM  EMAIL  Attn:RR
WATCH
 1 page 347 views TOPIC CLOSED
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › GV1 setup on trex nitro
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, June 22 - 4:26 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online