RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 506 views POST REPLY
HomeAircraftHelicopterSynergy R/COther › Hypergrips
03-04-2008 12:16 PM  10 years agoPost 1
DavidR

rrNovice

Oxford, MS

My Posts: All  Forum  Topic

I have a set of hypergrips and the button head screws that attach the cf arms are a pain to install and get tight. I stripped the head out of one of them trying to get it tight, does anyone know what size it is? I think the holes drilled in the CF are an interference fit instead of a clearance fit, just a hair too tight.

Thanks,
David Reid

PM  EMAIL  Attn:RR  Quote
03-05-2008 12:46 AM  10 years agoPost 2
Chuckie

rrKey Veteran

Crofton Maryland

My Posts: All  Forum  Topic

My cf arms were a little tight so I opened the hole using a small drill bit as a sanding device. I tested the hole size by tightening the button head screw into the cf arm only. I did the same as you on my metal head Tempest 3d and so I don't use the screws to pull in the arms into the grips.

Charles

Please stand by for faster service!

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 506 views POST REPLY
HomeAircraftHelicopterSynergy R/COther › Hypergrips
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, June 22 - 2:40 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online