Well, a few weeks ago I had a problem with my heli, and my ESC caught fire, I hadn't done anything with it because my Raptor was running good, but now I've got a little time, I decided to replace the ESC, so I did.
Soldered all my connections, turned radio on, plugged batter in. Got the 3 tone power on, then nothing, no control. So, I figured it might need to be programmed, so I increased throttle to maximum, and after a few seconds, it gave me the programming beeps, but couldn't do anything from there.
Disconnected everything, tried again, nothing, no beeps on power up nothing. ATV's set at 100, neutral trim, DX-7 radio with AR-6000 receiver.
All other functions are normal (rudder, cyclic, collective), just nothing from the ESC itself. Replaced the motor incase that was suspect, and same thing.
Any ideas? is it possible that it's bad without turning the motor at all?
Cheap, Fast and Reliable, pick any 2 !