RunRyder RC
WATCH
 1 page 560 views Post Reply
Home✈️Aircraft🚁HelicopterAlignOther › Bearing block orientaition...
08-05-2007 01:03 PM  13 years ago
Topic Vote0Post 1
JMF

rrApprentice

Clinton

MyPosts All Forum Topic
Bearing block orientaition...
I noticed on the bearing blocks thereis a small a or a b on the tab that goes into the frame. WIll it matter if one is upside down (in the right place) the A is upside down. I do not see a difference between either side. I konw A is on top, But does right side up matter?
SHARE  PM  EMAIL  Attn:RR  Quote
08-05-2007 09:03 PM  13 years ago
FlaHeli

rrApprentice

Jacksonville. Fl-USA

MyPosts All Forum Topic
JMF I never paid any attention to it since it was not mentioned in the directions and I didn't see any differences.
SHARE  PM  EMAIL  Attn:RR  Quote
08-07-2007 01:42 AM  13 years ago
JMF

rrApprentice

Clinton

MyPosts All Forum Topic
sounds good
SHARE  PM  EMAIL  Attn:RR  Quote
08-07-2007 02:07 AM  13 years ago
AzHyper

rrKey Veteran

Peoria, Az.

MyPosts All Forum Topic
When I was building mine I experimented with a few different permutations of A's and B's. It didn't make any difference on mine, but I was surprised at how much the plastic bearing blocks compress/flex due to "over" torqueing them causing main shaft drag. It's probably the right material for the job, but don't over do it and follow the cross pattern sequence as well.
SHARE  PM  EMAIL  Attn:RR  Quote
08-07-2007 03:23 AM  13 years ago
captrlp

rrVeteran

Spanish Fork, Utah - USA

MyPosts All Forum Topic
It doesnt matter the orientation as long as the "b" block is in the right location, ie, bottom position.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 560 views Post Reply
Home✈️Aircraft🚁HelicopterAlignOther › Bearing block orientaition...
Print TOPIC

 2  Topic Subscribe

Friday, September 25 - 2:23 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online