RunRyder RC
WATCH
 1 page 579 views Post Reply
Home✈️Aircraft🚁HelicopterAlignOther › Swash moves with cyclic input
08-05-2007 12:07 PM  13 years ago
Topic Vote0Post 1
woodscra

rrApprentice

Dallas, Texas

MyPosts All Forum Topic
Swash moves with cyclic input
When moving the cyclic, such as left/right aileron, the swash will move down a little the further I push the cyclic and then move back up towards center stick. The swash moves long before I get to extreme stick throw, therefore at that point it is not the amount of cyclic movement that causes the swash to move. The only think I can think of which remains is the servos do not move in-sync and this difference is enough to cause the swash to move.

Please share what you have found to cause this problem and what may be done to reduce or eliminate it. Thank you.
SHARE  PM  EMAIL  Attn:RR  Quote
08-05-2007 06:02 PM  13 years ago
Ville Erkkilä

rrApprentice

Oulu, Finland

MyPosts All Forum Topic
Hello,

If you have 14MZ, take a look at this thread: http://runryder.com/t357988p1/?highlight=interaction. You could also consider CSM Cyclock. Here's a review, http://www.trex-tuning.com/cyclock.php (remove - ).

Regards,
Ville Erkkilä
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
08-05-2007 06:06 PM  13 years ago
j5coat

rrVeteran

Phoenix

MyPosts All Forum Topic
is this a first setup with Eccpm?Trex 700, Trex 600n
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 579 views Post Reply
Home✈️Aircraft🚁HelicopterAlignOther › Swash moves with cyclic input
Print TOPIC

 2  Topic Subscribe

Monday, September 21 - 5:04 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online