RunRyder RC
WATCH
 1 page 480 views Post Reply
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › setting up arizona reg with 611 / GV-1 / 9303 - please help
08-04-2007 05:38 PM  13 years ago
Topic Vote0Post 1
Amarjit

rrApprentice

Chicago, IL

MyPosts All Forum Topic
setting up arizona reg with 611 / GV-1 / 9303 - please help
hi everyone

I am setting up the arizona regulator with a 9303 JR radio and 611 with a gv-1. I am using 'gear' channel on my receiver as the ability to turn the gv-1 on and off. My rpm's are controlled by the aux3 channel.

For the 611, I am using Aux 2 as the as the rx.aux wire from the 611, and the rx1-4 wire into the rudder channel on the receiver.

My question is what do I input into the arizona regulator? Do I do Aux2 and the rudder receiver channel? It states to use the gear channel, but my gear channel is occupied by the GV-1 to turn it on and off

Any help would be appreciated

Thanks!
Andy K
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
08-04-2007 06:59 PM  13 years ago
racer944

rrApprentice

Greely, Ontario - Canada

MyPosts All Forum Topic
Answer is yes...

It should'nt matter what you are using on the receiver as long as you plug the wires into the right corresponding sequence on the Arizona reg. For example, take the wire for the gyro gain out of the receiver and plug it into the gain spot on the reg. then plug the gain lead from the reg into the open spot you were using in the receiver for the gain from the 611. Do the same for the rudder.

Make sense?

Eric
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 480 views Post Reply
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › setting up arizona reg with 611 / GV-1 / 9303 - please help
Print TOPIC

 1  Topic Subscribe

Thursday, September 24 - 12:29 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online