RunRyder RC
WATCH
 1 page 1201 views Post Reply
Home✈️Aircraft🚁Helicoptere-Thunder TigerRaptor E325 › Video - Z-Power Z10A + FlightPower 2170 MaH
05-22-2007 02:32 AM  13 years ago
Topic Vote0Post 1
Bert Magbanua

rrNovice

CA

MyPosts All Forum Topic
Video - Z-Power Z10A + FlightPower 2170 MaH
A short video (due to gyro problems) of the E325 during a recent mini-funfly here in SoCal.

This Mini Titan is using a ZPower Z10A(15T) on FlightPower 2170 3S. Not sure of headspeed but delivers very good power with very little bog. Blades are Radix 325s.

Click on my gallery link below this post select the E325 under the videos heading.

Big thanks to Vic of SCHC for the vid.

- bert
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
05-22-2007 03:11 AM  13 years ago
AMainMaker

rrKey Veteran

Nappanee,IN

MyPosts All Forum Topic
Nice flying Bert you got that MT flying great

Jason Harmon
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
05-22-2007 07:40 PM  13 years ago
ngkimlong

rrNovice

USA

MyPosts All Forum Topic
Bert's Vids
Hi Bert,

Thanks for coming and having given us the sense of extreme 3Dz

ALl your vids on Raptor e620, Mini Titan and Raptor 90. SE were posted at SCHC official website in high quality. Here is the Link:

http://socahc.com/main/index.php?op...&g2_itemId=1568

Team SCHC.
SHARE  PM  EMAIL  Attn:RR  Quote
05-23-2007 01:12 AM  13 years ago
Glenn Cain

rrApprentice

Singapore

MyPosts All Forum Topic
The movements are really nice and crisp, closer to a larger heli in flight, and less like alot of mini heli movie i have seen. other than the z10, really has to the work of fingers.
SHARE  PM  EMAIL  Attn:RR  Quote
05-23-2007 08:36 AM  13 years ago
RSA

rrApprentice

Phnom Penh

MyPosts All Forum Topic
Hi Bert,
could you list down your tail set up? it seems very fast..
i have a 9650 @4.8v and its really slow...
thank you
SHARE  PM  EMAIL  Attn:RR  Quote
05-24-2007 07:01 AM  13 years ago
Bert Magbanua

rrNovice

CA

MyPosts All Forum Topic
Sorry for the delay... work and training..

Anyways, tail is all stock w/Futaba GY401+9650 off of an Align ESC (guessing 5V).

Tail setup:

1. Set STRIM, TRIM to zero and ATVs to 100 in all flight modes.
2. Center servo by turning on the RX (and GY)
3. Re-place the horn so it is centered (center of travel)
4. Make sure end points are even by adjusting linkage
5. Adjust the end point travel from the GY's potentiometer

To increase speed, simply increase the rudder ATVs (or EPAs). My tail is not that fast. I've only set something like 120% on the ATVs for that speed. It can go much faster if you like.

PS: Thanks guys!

- Bert
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
05-29-2007 03:16 PM  13 years ago
whyfly

rrVeteran

Temecula C.A.

MyPosts All Forum Topic
Bert,

Nice flying, I had my eye on that same set up for my Titan.
I finally got the motor installed and the Radix on and man what a sweet heli my temps are 90 on the motor and 115 on the lipo and 100 ESC.Heli so sweet I did not touch my trex this weekend looks like I'll have two blinged out Trex for sale soon.....
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
05-30-2007 12:42 AM  13 years ago
fiordaliso

rrApprentice

Bregenz/Austria

MyPosts All Forum Topic
Hi to all!

I am actually testing some motors and pinions.

Last motor was a Hacker A20 6 XL with different pinions.
The Hacker does not have such high rpm as the stock one.
With the p13 headspeed seemed to low and for harder 3D it lacked punch.
With the p17 headspeed was great but I had problems with blade tracking. Pitch and cyclic reaction were crisp.
Now I will try the 16 tooth.

The stock motor was really good but showed some weakness sometimes.
But I only tried the 13 tooth pinion which maybe was a bit to much.
Did anybody try the 11 tooth pinion?

What are your experiences?
Bert, what motor/pinion combo did you usually use?

What combination shows consistent and best power?

Thanks a lot for your replies!

Michael
SHARE  PM  EMAIL  Attn:RR  Quote
05-30-2007 12:45 AM  13 years ago
fiordaliso

rrApprentice

Bregenz/Austria

MyPosts All Forum Topic
Sorry Bert, I just saw what motor/pinion you used! ;-)

Impressive...
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 1201 views Post Reply
Home✈️Aircraft🚁Helicoptere-Thunder TigerRaptor E325 › Video - Z-Power Z10A + FlightPower 2170 MaH
Print TOPIC

 2  Topic Subscribe

Friday, January 15 - 9:15 pm - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online