RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 563 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › GV1 limit error.
11-27-2006 03:01 AM  11 years agoPost 1
scriber

rrApprentice

New York, NY

My Posts: All  Forum  Topic

Trying to set the limits on the GV1. idle/high/stop then error.
My atv's are 125% and 100%. My stop is lower than my idle. I set to be operated by a switch. Not sure what it could be. Any ideas?

PM  EMAIL  Attn:RR  Quote
11-27-2006 12:22 PM  11 years agoPost 2
Alexander01

rrVeteran

Sweden

My Posts: All  Forum  Topic

Try the following:

Set IDLE position on the GV1 by raising the throttle stick a little from the bottom. Then lower the stick all the way and hit throttle cut to set CUT on the GV1.

PM  EMAIL  GALLERY  Attn:RR  Quote
11-27-2006 01:50 PM  11 years agoPost 3
BarracudaHockey

rrMaster

Jacksonville FL

My Posts: All  Forum  Topic

Not that its your problem but if your atv's arent equal your throttle linkage isnt set up right to begin with.

Andy
AMA 77227
http://www.jaxrc.com

PM  EMAIL  GALLERY  Attn:RR  Quote
11-28-2006 05:16 AM  11 years agoPost 4
crazeepilot

rrApprentice

san francisco

My Posts: All  Forum  Topic

I agree with BarracudaHockey....Also if your throttle trim is lower than half, it could also give you a error message....

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 563 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › GV1 limit error.
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Wednesday, June 20 - 6:30 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online