RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 453 views POST REPLY
11-23-2006 11:01 PM  11 years agoPost 1
smallplanes

rrElite Veteran

S.C. ,SSA

My Posts: All  Forum  Topic

I have a Throttle jockey revmax limiter that i'm putting on an evo 50 with a hyper 50. I have it installed and calibrated now what i need to know is how i go about the setup in the governor screen in my 12ZH? I've read the instrutions alot of times and i've gone to raptortech.com and i'm still a little confused,i think i might could use the ATV(or end points) but i want to use the governor screen in the tx.

One more thing, my fan had a magnet hole allready in it from the factory on one side. I drilled a small hole tru it with my dremal and put 30min epoxy in it. Do i need to take the motor out and the fan off and balance it? Any help or tips would be great.

Thanks

2 evo 50's with hyper 50's mp2's
2 trex's XL,SA

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
11-24-2006 08:56 PM  11 years agoPost 2
smallplanes

rrElite Veteran

S.C. ,SSA

My Posts: All  Forum  Topic

Does anyone know if the RevMax puts off interference? I got it setup upon my NEW Evo 50 and i was on the 3rd flight hovering it about 15ft when all of a sudden it went out of control. I got it back and leveled it off and start to back it up to set it down and then it went utof control again , i was able to cut the throttle and it went in on its side in a muddy field. It broke my brand new MAH 600's and it got my 9253 servo , fly bar and it bent the boom just a little, everything esle is ok. I range checked the heli before i flu it, so i'm not sure what went wrong. I have the wires going the the rx ant. about 1/2 away Any ideas?

Thanks for any help

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
11-24-2006 10:38 PM  11 years agoPost 3
Droid

rrElite Veteran

Deep down in the Southwest- UK

My Posts: All  Forum  Topic

Yes its a signal generator! Keep it away from the Rx antenna, some have suggested a ferrite ring on the signal wire to cut noise , i would keep it as far from the Rx as possible.

Quotes may have been changed for my own amusement

PM  EMAIL  GALLERY  Attn:RR  Quote
11-25-2006 02:21 AM  11 years agoPost 4
smallplanes

rrElite Veteran

S.C. ,SSA

My Posts: All  Forum  Topic

I forgot to mention that the revmax was off at the time of the crash. Would it cause RF if its not turned on? I think it might have been my tail servo 9253 because after the crash it will work for a minute then it will quit.

Thanks for any help

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
11-25-2006 02:36 AM  11 years agoPost 5
smallplanes

rrElite Veteran

S.C. ,SSA

My Posts: All  Forum  Topic

Here are the pics of the way i have it mounted.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 453 views POST REPLY
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, June 19 - 8:02 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online