RunRyder RC
WATCH
 1 page 409 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignOther › Better design for tail
09-10-2006 07:21 AM  14 years ago
Topic Vote0Post 1
Rocketwiz

rrNovice

Lakewood CO

MyPosts All Forum Topic
Better design for tail
Maybe I'm missing something here but why don't they built the tail box with the screws coming out the other side. If they did you could remove the fin, remove the screws, lift the left side of the housing and replace the belt without having to disturb any of the rotor parts or linkage. Should be totally obvious to the most casual observer it would be better than the present design. If Align reads this, I'd be willing to test their prototype if they'll send it gratis.


Bert
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
09-10-2006 07:52 AM  14 years ago
caseyjholmes

rrElite Veteran

Portland, Oregon

MyPosts All Forum Topic
If you find it THAT annoying,
you can put the tail shaft out the other side of the tail gearbox and flip everything over. (that is, if it is an SE tail gearbox)
Tail belt idler pully on the bottom, but fin still on the same side and screws on the fin side.
If Align reads this, I'd be willing to test their prototype if they'll send it gratis.
good luck on that one..
I'd think they'd hand it to one of the factory pilots for test flights.
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 409 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignOther › Better design for tail
Print TOPIC

 1  Topic Subscribe

Saturday, November 28 - 5:21 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online