RunRyder RC
WATCH
 1 page 360 views Post Reply
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Servo - Gyro - Gov - Batt › E-Station 902 charger - 10 cell li-po question
09-07-2006 01:05 AM  14 years ago
Topic Vote0Post 1
jwpjr

rrNovice

Tampa, FL USA

MyPosts All Forum Topic
E-Station 902 charger - 10 cell li-po question
I have two five cell li-po batteries that are being charged with the e-station 902. I have charged these batteries several times but this time I get an error message (VOL SEL ERROR) about three minutes after starting the charge. The 902 manual has a rather cryptic explanation of this display message and refers to a deep-discharged or over-charged condition.

I notice when I go through the steps to start the charge cycle that the screen telling me how many cells have been detected says 9 but the number of cells selected says 10.

Hmmm.. I am totally new to this whole electric helicopter thing.

Suggestions?

PS I have a OutDoo 600 that was assembled by the Quick and I have had it for less than a week so I'm just getting into the nitty-gritty of working with it. I have flown it several times and all has seemed well aside from some minor issues with the rudder push rod that appear to have been settled.

Irwin, et al, at Quick have been VERY helpful, but I don't want to wear out my welcome by asking questions all the time and thought perhaps someone here might have some suggestions.

A million thanks!
SHARE  PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 360 views Post Reply
HomeRC & Power✈️Aircraft🚁HelicopterRadio - Servo - Gyro - Gov - Batt › E-Station 902 charger - 10 cell li-po question
Print TOPIC

 1  Topic Subscribe

Friday, December 4 - 2:19 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online