RunRyder RC
WATCH
 1 page 339 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignOther › Rotorworkz G4/HS-56 servo arm rub
09-04-2006 04:52 PM  14 years ago
Topic Vote0Post 1
cudaboy_71

rrElite Veteran

sacramento, ca, u.s.

MyPosts All Forum Topic
Rotorworkz G4/HS-56 servo arm rub
I just put together a G4 t-rex with HS-56 servos. using the 2nd innermost hole on the cyclic arms, the nut on the right (from the rear) servo arm rubs the lower hex-head screw on the upper portion of the frame. it only interacts at full right and full negative.

is this normal, or might i have somthing aligned/installed wrong.

if this is normal, what is the typical solution? filing the nut on the back of the ball link? filing down the blue hex screw? something else?
if it ain't broke, break it.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-04-2006 05:09 PM  14 years ago
philip 01

rrElite Veteran

ft worth

MyPosts All Forum Topic
i just looked at mine. i do not have a nut on that ball. it is threaded in the horn with ca and feels tight.

i have been flying it that way for some time. i flip and flop the heck out of it and have had no problems.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-04-2006 05:13 PM  14 years ago
Foxden

rrElite Veteran

Port Charlotte, FL. USA

MyPosts All Forum Topic
I just ground down the nut and end of the horn with my dremelClyde Fox
Port Charlotte FL
Team Outrage
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-04-2006 05:31 PM  14 years ago
cudaboy_71

rrElite Veteran

sacramento, ca, u.s.

MyPosts All Forum Topic
ok..thanks. i mainly wanted to make sure i didnt have something installed wrong. guess i'll grind down that nut.if it ain't broke, break it.
SHARE  PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 339 views Post Reply
Home✈️Aircraft🚁Helicoptere-AlignOther › Rotorworkz G4/HS-56 servo arm rub
Print TOPIC

 2  Topic Subscribe

Sunday, November 29 - 3:46 am - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online