RunRyder RC
WATCH
 1 page 453 views Post Reply
Home✈️Aircraft🚁HelicopterBeginners Corner › CF Balanced?
07-18-2006 08:22 AM  14 years ago
Topic Vote0Post 1
702nitro

rrKey Veteran

Las Vegas, NV

MyPosts All Forum Topic
CF Balanced?
The blades that i'm balancing are the Thunder Tiger Carbon Fiber 550mm black/white blades. The center of gravity on one blade is 1mm or at most 2mm off from the other, but very very unlikely. As far as weight differences, the bubble in the level were between the two lines.

Are these blades good to go???
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
07-18-2006 08:54 PM  14 years ago
Yug

rrMaster

UK. Herts

MyPosts All Forum Topic
keep balancing

I tend to try and get CGs well within 0.5mm and blade weights within 0.2g on the mains.
Vegetable rights and Peace
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
07-18-2006 09:30 PM  14 years ago
702nitro

rrKey Veteran

Las Vegas, NV

MyPosts All Forum Topic
I tried to get the two points to match as close as possible, but it would require a small strip of balancing tape (.5" x .5". If i'm using that little balancing tape, is it really necessary?

Thanks Yug
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
07-18-2006 09:40 PM  14 years ago
Yug

rrMaster

UK. Herts

MyPosts All Forum Topic
The better the balancing, the smoother it runs. In my view, it is worth putting some effort into getting it as good as you can. However, half inch square is not that much so you're probably OK. Depends where this is required, but you could remove some material from the heavier blade.Vegetable rights and Peace
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 453 views Post Reply
Home✈️Aircraft🚁HelicopterBeginners Corner › CF Balanced?
Print TOPIC

 1  Topic Subscribe

Sunday, June 20 - 11:39 am - Copyright © 2000-2021 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online