RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 646 views POST REPLY
HomeAircraftHelicopter
e-
Blade
Other › blade cx controller help
02-13-2006 02:33 AM  12 years agoPost 1
proxsprint

rrNovice

winnipeg,manitoba,ca nada

My Posts: All  Forum  Topic

is it possible to adjust the tension on the rudder stick, it seems awfully stiff and would be easier to operate if the spring tension wasnt so strong, any suggestions,thanks for any help

http://motorsports-addiction.com/Richard_Rogers.html

PM  EMAIL  Attn:RR  Quote
02-13-2006 03:00 AM  12 years agoPost 2
new flyer 101

rrApprentice

westborough ma usa

My Posts: All  Forum  Topic

sticky rudder
you could open the trans up i think if you remove the 4 screws on the left front stick bezel you can pull the stick assy out. just remove the spring and stretch it a bit not too much! try and then feel it then try again till its correct. also you might have wires ect on the inside that may be in the way and causing that to happen.

or just remove the 4 screws from the radio housing and do it that way the key is to stretch the spring a bit

PM  EMAIL  GALLERY  Attn:RR  Quote
02-13-2006 06:03 PM  12 years agoPost 3
DAG

rrNovice

Connecticut

My Posts: All  Forum  Topic

Put a short piece of silicone fule line hose on the spring clip inside the Tx and you can get rid of that ratchet feel, making it real smooth to control and more precise.

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
02-13-2006 09:29 PM  12 years agoPost 4
speeder

rrNovice

Vermillion, SD

My Posts: All  Forum  Topic

I just flipped the spring over and reassembled. You still get friction but no ratchet.

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 646 views POST REPLY
HomeAircraftHelicopter
e-
Blade
Other › blade cx controller help
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Monday, June 18 - 10:27 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online