RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 382 views POST REPLY
HomeAircraftHelicopterMain Discussion › 3D PRO Elite set up on servos help ?
02-11-2006 11:04 PM  12 years agoPost 1
tomuchfun

rrNovice

Cardington ,Ohio,

My Posts: All  Forum  Topic

I'm trying to set up the 120 ccpm and having some trouble , I'm not sure if one or more of the servos need reversed .I'm useing a JR 652 . Question,,? What position should the the swash plate be for forward motion ,Tilted forward correct? If this is true, then I just reverse the elevater servo, correct? ? And as long as ail ,and pitch go left and right as imput from sticks then they should be ok? correct ? .. The mixing is on and seems to work ok ,

I was doing the set up and noticed when I would input up on the stick the swash tilted back ...... I did a reverse on servo and all seemed to go out of wack ... Before I try to get to ground zero again ,I wanted to be sure I'm on the right track ....thanks already
rt
I just noticed that when I reverse the elevater servo the other two,, pitch ,and ail. move in the same direction , when I input for forward flight on the stick in effect lifting or lowering the swash but at a slower rate ... Is this part where I need to set percent of mix ? thanks rt

PM  EMAIL  Attn:RR  Quote
02-11-2006 11:47 PM  12 years agoPost 2
SteveH

rrProfessor

Texas

My Posts: All  Forum  Topic

Don't reverse the channel, go to the AFR settings and reverse the elevator from say +75 to -75%.

The government cannot give you anything without first taking it from someone else.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 382 views POST REPLY
HomeAircraftHelicopterMain Discussion › 3D PRO Elite set up on servos help ?
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Saturday, June 23 - 9:30 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online