RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 454 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › 9303- GV-1 programming
02-09-2006 02:04 PM  12 years agoPost 1
Bladebuster

rrApprentice

Bayside N.Y.

My Posts: All  Forum  Topic

Tried this question in Gassers.No response
I have been trying to figure out how to program my gv-1 with my jr9303. This is the first time i am using a governor, and i am still learning how to use the transmitter. I've tried doing a search,but with all the different opinions, and answers that were a little vague, i was getting more confused. If someone could take the time to go step by step into the setup, it would be greatly appreciated.
I am using the gv-1 with a stator gator in a z230 gasser. Do most of you use the idle up switch to contol the rpms? Is there a better way?
Right now without the gv-1, my rpms are 1650 in normal and about 1750 in idle up 1. So, how do i program these numbers into the radio and the governor. thanks

PM  EMAIL  GALLERY  Attn:RR  Quote
02-11-2006 03:35 AM  12 years agoPost 2
imback

rrApprentice

las vegas, nevada

My Posts: All  Forum  Topic

bladebuster
run a search of "gv-1 and 8103". you will find the information. the 9303 is basically the same radio.

i have not set up a governor in a couple of years and my oldtimers prevents me from remembering how to do it.

nels

just do it!

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 454 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › 9303- GV-1 programming
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Thursday, June 21 - 3:37 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online