RunRyder RC
WATCH
 1 page 1294 views POST REPLY
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › Instruction manual for JR 500T Gyro?
01-16-2006 12:03 AM  13 years ago
Topic Vote0Post 1
Crush

rrApprentice

York, PA

MyPosts All Forum Topic
Instruction manual for JR 500T Gyro?
Does anyone have a link for online instructions. JR 500T Gyro.
"Learning from mistakes gets expensive"
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-16-2006 12:16 AM  13 years ago
heli_jon

rrApprentice

Calgary, Alberta

MyPosts All Forum Topic
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-16-2006 02:37 AM  13 years ago
Crush

rrApprentice

York, PA

MyPosts All Forum Topic
Thanks"Learning from mistakes gets expensive"
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-16-2006 10:41 AM  13 years ago
nivlek

rrProfessor

Norfolk England

MyPosts All Forum Topic
I would suggest setting the rudder travel adjusts at 100% , not the 150% it says in the instructions , 150% gives an absolutely blinding piro speed . I destroyed the gears in a servo using the 150% , doing super fast piros with instantaneous stops !At the end of the day , it gets dark .
SHARE  PM  EMAIL  Attn:RR  Quote
01-16-2006 01:23 PM  13 years ago
freezin Eskimo

rrApprentice

Flagstaff,AZ 86004

MyPosts All Forum Topic
JR 500T Connections and set-up

-Plug the white AUX connector into the AUX channel you wish to use for gain
- set your tail rotor servo horn to between 16-18mm from center of rotation to ball link.
-Set rudder ATV/Travel Adjust to 150% both ways and do not adjust!
-Set Rudder dual rates to determine piro Rate. A good starting value is 55% and can be increased at pilot’s discretion. Note: start with a low setting and work up as a 100% value can be violent and blow a crown gear or cause loss of control. Make sure to set all of the stick positions for dual rate and expo! (Don’t forget to set both sides of the switch and leave one at 100% default!)
-Rudder Expo sets how hard the gyro hits. Start out with a high number (50-60%) and work up or down from there.
-Gyro gains needs to be as high as possible without wagging (if gyro wags reduce speed immediately to stop wag, land and reduce gain. See Chart for gain values!


Use the ATV Output% to set gyro to either Heading Hold or Rate Mode. Each % of output equals 2% Gyro Gain
Gyro sensitivity function is desirable to select gyro gain

Example: 85% ATV/Travel Adjust value equals 70% gyro gain is Heading hold mode. 15% ATV/Travel Adjust is equal to 70% Rate mode gain.

ATV% Gain%
100 = 100
90 = 80
80 = 60
70 = 40
60 = 20
50 = 0 HH = 50% Or Higher ATV,Non HH = 50% Or Less ATV
40 = 20
30 = 40
20 = 60
10 = 80
0 = 100
Just Enjoy The Ride!
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-17-2006 02:22 AM  13 years ago
Crush

rrApprentice

York, PA

MyPosts All Forum Topic
hey...thanks for taking the time to explain how to set it up."Learning from mistakes gets expensive"
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
01-17-2006 02:32 AM  13 years ago
freezin Eskimo

rrApprentice

Flagstaff,AZ 86004

MyPosts All Forum Topic
all i did was cut an past from John Garsts Explaination on HF.

Karl
Just Enjoy The Ride!
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1294 views POST REPLY
Home✈️Aircraft🚁HelicopterHelicopter Main Discussion › Instruction manual for JR 500T Gyro?
 Print TOPIC  Make Suggestion 

 4  Topic Subscribe

Sunday, September 15 - 11:04 pm - Copyright © 2000-2019 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online