RunRyder RC
WATCH
 1 page 427 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › FUTABA END POINTS QUESTION
12-04-2005 02:55 PM  12 years agoPost 1
jpalmer

rrApprentice

Meadville, PA

My Posts: All  Forum  Topic

I just noticed this. With 7CHP and S9402 servos, on collective pitch channel 6, the servo will not move after reaching 110% on the End Point adjustment. In other words, if I hold the stick full either direction and start increasing the E. Point, when the E. Point hits 110% the servo will not move any further. If I go ahead and set the E. Point to its max. (140%), then the servo will not move until the stick has come off its full limit of travel about 5 degrees.

I bought a new servo, thinking that was the problem, but it does the same thing. The other channels do not exhibit this. In other words, the servo keeps turning all the way to 140%.

Your thoughts? Thanks, Joe....

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 427 views POST REPLY
HomeAircraftHelicopterRadio - Servo - Gyro - Gov - Batt › FUTABA END POINTS QUESTION
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, July 17 - 10:13 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online