RunRyder RC
WATCH
 1 page 486 views POST REPLY
Home✈️Aircraft🚁Helicoptere-AlignOther › Fixing the Trex?
11-09-2005 03:45 PM  14 years ago
Topic Vote0Post 1
BellX1

rrNovice

Ohio

MyPosts All Forum Topic
Fixing the Trex?
I bought my Trex second had already assembled. I had a little accident and need to replace the main shaft and gear.

Does the main shaft press fit into the head ( align CNC head) ?
I have it apart but cannot easily pull the shaft from the head, I'm not sure how much pressure I should apply and don't want to damage anything by trying to remove it with too much force.

Any helpful repair tips would be greatly appreciated.
SHARE  PM  EMAIL  Attn:RR  Quote
11-09-2005 03:52 PM  14 years ago
Buznee

rrVeteran

Palm Beach Gardens, FL

MyPosts All Forum Topic
there is a nut and bolt holding the shaft to the head. remove them and then it should pull apart.~Danny
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
11-09-2005 04:00 PM  14 years ago
BellX1

rrNovice

Ohio

MyPosts All Forum Topic
I did remove the nut and bolt, but its really snug in there. I put a little elbow grease in it and pull it out. Just seems really tight in there.

I put an allen wrench in the bottom hole where the gear is secured trying to twist and pull and it snapped the wrench.

Cheers.
SHARE  PM  EMAIL  Attn:RR  Quote
11-09-2005 05:55 PM  14 years ago
steph

rrKey Veteran

Hampshire England

MyPosts All Forum Topic
Hi

I sounds like the last owner mudst have lock tighted the shaft to the head try a little heat from a heat gun that might work it should just pull out
The world is round you can run but you will always end up where you started from
SHARE  PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 486 views POST REPLY
Home✈️Aircraft🚁Helicoptere-AlignOther › Fixing the Trex?
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, July 4 - 7:44 pm - Copyright © 2000-2020 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online