RunRyder RC
WATCH
 1 page 580 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › Airsupply 40 into Raptor 30
10-11-2005 01:23 PM  12 years agoPost 1
lardyboy

rrNovice

Channel Islands

My Posts: All  Forum  Topic

Hi Guys,

About to fit an airsupply 40 into m6y raptor 30 but it doesn't seem to line up.

When I slip the engine in place it sits too low by about 2 - 3 mm and I cannot get the engine mounts to line up with the frame, any suggestions ?

if it aint goin fast enough through more money at it !!!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-13-2005 06:27 AM  12 years agoPost 2
J3DI

rrVeteran

Oswestry, Shropshire. UK

My Posts: All  Forum  Topic

Is this one of those engines that requires a prop driver on the crankshaft before you fit the fan?? Can't remember if i read this somewhere...

PM  EMAIL  GALLERY  Attn:RR  Quote
10-13-2005 07:57 PM  12 years agoPost 3
lardyboy

rrNovice

Channel Islands

My Posts: All  Forum  Topic

40 into Raptor
Turns out it was the head cathing on the servo shelf - Bit of a dremmel and it slips in fine

if it aint goin fast enough through more money at it !!!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-14-2005 11:18 PM  12 years agoPost 4
PaulJC

rrElite Veteran

Hertfordshire UK

My Posts: All  Forum  Topic

I'm sure it was a recent article in model helicopter word that stated it need a prop nut, might be model depended though

PM  EMAIL  GALLERY  Attn:RR  Quote
10-16-2005 02:14 AM  12 years agoPost 5
CT.Chopper

rrVeteran

Meriden, CT

My Posts: All  Forum  Topic

paul that was the tiger 50

diffrent machine.

Rob Landry.

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 580 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › Airsupply 40 into Raptor 30
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Sunday, July 22 - 12:08 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online