RunRyder RC
WATCH
 1 page 397 views POST REPLY
HomeAircraftHelicopter
e-
Align
Other › Align 35 ESC glitch
10-10-2005 11:45 PM  12 years agoPost 1
johandheere

rrNovice

Brussels - Belgium

My Posts: All  Forum  Topic

Hello I'm using for the first time the Align 35 ESC in combination with the 420LF. I noticed serious glitching after 7min of normal flying. I was very surprised because I use a Futaba PCM receiver....

I think I'll change the controller for a CC25, in the past I never had problems with this one....
In the past I was also using an ACT gyro and tried a Telebee now...
Can the glitching be caused by the gyro or would it be the controller?

Is the CC25 sufficient for the 420LF?

PM  EMAIL  Attn:RR  Quote
10-10-2005 11:48 PM  12 years agoPost 2
Helichomper

rrApprentice

san diego,ca

My Posts: All  Forum  Topic

make sure all your wires are away from the controller, if not this will cause glitching

PM  EMAIL  Attn:RR  Quote
10-11-2005 12:29 AM  12 years agoPost 3
johandheere

rrNovice

Brussels - Belgium

My Posts: All  Forum  Topic

All wires are away from the controller and controller is placed at the rear, receiver in front...


Weird thing is that glitching starts occuring after appr. 7min of flight time, when battery power decreases a bit...

PM  EMAIL  Attn:RR  Quote
10-11-2005 01:03 AM  12 years agoPost 4
Helichomper

rrApprentice

san diego,ca

My Posts: All  Forum  Topic

maybe you need to go to a smaller pinon so your battery doesn't pull so much power. I use the align 35 amp with the 400dh motor with a nine tooth pinon, and can fly for12 minutes with no glitches at all. I use the eclipes 7 radio

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 397 views POST REPLY
HomeAircraftHelicopter
e-
Align
Other › Align 35 ESC glitch
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, July 16 - 12:00 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online