RunRyder RC
WATCH
 1 page 409 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › mp2 pressure line screwed up!
05-03-2005 03:16 AM  13 years agoPost 1
SRXripper

rrApprentice

ocala, fl

My Posts: All  Forum  Topic

installed my new mp2 but failed to see the pre tapped hole and drilled and installed the nipple on the center of the large portion of the pipe.

will this cause a bad pressure supply to the engine? even if i cap off were the nipple was supposed to go!

EVO50, OS50, JR8103DT, 9252's, Gy401/9254

PM  EMAIL  GALLERY  Attn:RR  Quote
05-03-2005 03:19 AM  13 years agoPost 2
TMoore

rrMaster

Cookeville, TN

My Posts: All  Forum  Topic

Actually, that is a good place to mount the pressure fitting. Just plug the original hole and go fly.

TM

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
05-03-2005 03:39 AM  13 years agoPost 3
SRXripper

rrApprentice

ocala, fl

My Posts: All  Forum  Topic

thanks!

EVO50, OS50, JR8103DT, 9252's, Gy401/9254

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 409 views POST REPLY
HomeAircraftHelicopterEngines Plugs Mufflers Fuel › mp2 pressure line screwed up!
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, July 23 - 1:31 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online