RunRyder RC
WATCH
 1 page 502 views POST REPLY
HomeAircraftHelicopterComputer Flight SimulatorsOther › How Do you set ATV in G3
03-30-2005 03:57 AM  13 years agoPost 1
Linley

rrApprentice

Rockville Centre - LongIsland, New York

My Posts: All  Forum  Topic

I just purchased G3 and having trouble setting up the helis. In one of the Helis the rudder rate is too high and I cannot figure out how to adjust the ATV or Rudder rate - Please help

Thanks

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
03-30-2005 04:38 AM  13 years agoPost 2
vitek

rrKey Veteran

Corvallis, OR

My Posts: All  Forum  Topic

I'm assuming that you are using the Interlink Plus controller and not your own radio.

You can change the pirouette rate pretty easily, you just need to know where to look. You can change the value in two places. You can adjust the pirouette rate on the gyro, or you can do it with the rudder ATV.

To edit the rate on the gyro amp, click Aircraft | Edit to bring up the Aircraft Editor dialog. On the left you should see a tree view. Click the + next to Electronics, then click Heading Hold Gyro. The parameter you are looking for is named Heading Hold Rotation Rate. Lower values give a slower pirouette rate.

To edit the rate in the Rudder ATV, Click the + next to Software Radio, then click the + next to Output Channel 4. Channel 4 is the rudder channel on most transmitters. Click Input and find the value named Percent. This is the ATV/AFR for the rudder channel. Reducing the value will result in slower pirouette rates. You could also use the Low Rates and Exponential items just above that to get a similar effect.

Travis
Software Developer
Knife Edge Software

PM  EMAIL  GALLERY  Attn:RR  Quote
03-30-2005 05:30 AM  13 years agoPost 3
Linley

rrApprentice

Rockville Centre - LongIsland, New York

My Posts: All  Forum  Topic

Thank you
Thank you so much - Will give this try

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 502 views POST REPLY
HomeAircraftHelicopterComputer Flight SimulatorsOther › How Do you set ATV in G3
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Monday, July 23 - 5:24 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online