RunRyder RC
WATCH
 1 page 916 views POST REPLY
03-28-2005 06:52 PM  13 years agoPost 1
clovis

rrNovice

Montreal

My Posts: All  Forum  Topic

Hi,
I am looking to get a Corona. I will go brushless right away. Reading the post on the Corona, I think I will get an Axi 2814/10. The question I have is regarding the pinion. From what I read, for this motor I would need something between 17 to 19 teeth pinion gear. Could you tell me what pitch are the gear in the Corona. Also if you could tell me what are the best gear to order.

Thanks a lot,
Clovis

PM  EMAIL  Attn:RR  Quote
03-28-2005 07:14 PM  13 years agoPost 2
jfischer

rrNovice

Manassas, Virginia

My Posts: All  Forum  Topic

They use a 32 pitch and on a stock Corona it is a 9 tooth, so what you are looking at is way high.

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
03-28-2005 07:38 PM  13 years agoPost 3
clovis

rrNovice

Montreal

My Posts: All  Forum  Topic

Yes, but the AXI is a low RPM, High torq motor. This is why I need 17 to 19 pinion.

Thank for the info about the pitch.
Clovis

PM  EMAIL  Attn:RR  Quote
03-28-2005 08:13 PM  13 years agoPost 4
jfischer

rrNovice

Manassas, Virginia

My Posts: All  Forum  Topic

Then go for it, I think you will heat your bateries and controller up with a low RPM motor. Why don't you just go with what others have found works.

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
03-28-2005 10:23 PM  13 years agoPost 5
clovis

rrNovice

Montreal

My Posts: All  Forum  Topic

PM  EMAIL  Attn:RR  Quote
03-29-2005 06:33 AM  13 years agoPost 6
askman

rrApprentice

willamette valley, Oregon

My Posts: All  Forum  Topic

well, axi motor is 5mm shaft, which means you will have to drill a gear out (or get one setup for 5mm)

for 3.2mm shaft, I've used Traxxas Emaxx rc car pinion. for 5mm shaft though, I don't know if there is enough meat to drill out. Robinson racing pinion gear will work, but they are bit on the smaller side. (there is enough meat there to drill though) you may be able to get one from SDP-SI.com.

most people run 2820/10 motor with Ballistic Technology belt drive. it is 4:1 ratio belt drive and works great. (I have a setup with mega RC600-6 motor with this belt system)

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 916 views POST REPLY
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, July 16 - 3:55 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online