RunRyder RC
WATCH
 1 page 781 views POST REPLY
07-17-2002 02:01 AM  16 years agoPost 1
RussNY

rrNovice

Stonybrook, NY

My Posts: All  Forum  Topic

Any one know how to use the swashplate level? It does not seem to fit on to the shaft unless I pop off all the links above the swash plate. Is that right?

thx
Russ

PM  EMAIL  Attn:RR  Quote
07-17-2002 02:42 AM  16 years agoPost 2
Zooms Heli

rrApprentice

Los Angeles

My Posts: All  Forum  Topic

Russ,
That is correct. Remove the links from top of the swash. Make sure your table is perfectly level. Once your swash is level re-attach the links and adjust your pitch from the links above the swash. Make sure you do this with 0 trim, and make sure that your servos a zero'd properly with the servo head in the proper position prior to using the level.

Hope this helps.
Scott

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
07-17-2002 03:56 AM  16 years agoPost 3
RussNY

rrNovice

Stonybrook, NY

My Posts: All  Forum  Topic

thanks Scott
I popped off the top links and used the swashplate level gauge.
My only problem I can see while flying is some aileron input while doing loops. The levels show some interaction between elevator and aleiron. I could not see this by eye.

I found some more large wheels so when I get some time I am going to spend the time to do it right.

Regards
Russ

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 781 views POST REPLY
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Sunday, July 22 - 8:03 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online