RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 408 views POST REPLY
HomeAircraftHelicopterMain Discussion › Metal tail case issue!
11-06-2004 11:22 PM  13 years agoPost 1
shykmaster

rrApprentice

New York

My Posts: All  Forum  Topic

regarding using only 1 grub screw
I noticed that one of you mentioned that you are supposed to use only one grub screw to hold the tail on the shaft in a metal tail system. Why is that if you can use 2 than why not use them.
I just got a metal tail case and in my Rappy, and doing low hovering, the tail suddenly beang piroetting and I too got lucky and was able to land with no damage. Upon inspection I noticed that the rotor assembly was loose on the shaft. There was only one grub screw holding it on and it was loose. Well, I tightened it up and added another grubb screw to the opposite side. Is this not O.K.???

Thank,
Josh
Raptor 50

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 408 views POST REPLY
HomeAircraftHelicopterMain Discussion › Metal tail case issue!
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, June 19 - 1:44 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online