RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 503 views POST REPLY
HomeAircraftHelicopter
e-
Electric General Discussion
› seperates question 401
11-03-2004 09:43 PM  13 years agoPost 1
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

O k guys I am setting up my first cp hummingbird with seperates and I have a few questions. I am using a 401 gyro DD tail and ics 50 for the tail esc, I have the motor wires connected and I know that the main power gets connected to the main esc wires and then to the battery right? know what;s left is the gyro how do I run this there is a plug that goes right in but I have read something about disabling a bec in the tail esc How do you do this and how do you wire this up, I have saw the seperates info on helihobby but I cannot make that much out of it. Thanks for the help guys I can;t wait to try her out.

PM  EMAIL  GALLERY  Attn:RR  Quote
11-03-2004 11:06 PM  13 years agoPost 2
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

anybody?

PM  EMAIL  GALLERY  Attn:RR  Quote
11-04-2004 09:55 AM  13 years agoPost 3
Shanti

rrNovice

Israel

My Posts: All  Forum  Topic

Hi

Sorry but you did not provide enough details regarding your configuration.

What do you use as main esc?
Do you have a separate receiver?

If you use a separate receive than you need a 6 channel receiver to use GY-401. The 401 has to input which you connect to channels 4 (rudder input) and 5 (Gain). The 401 output is connected to the tail esc.

Shanti

PM  EMAIL  Attn:RR  Quote
11-04-2004 01:25 PM  13 years agoPost 4
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

Sorry I have a himax 2015 4100 and phx 10 ics 50 for tail DD tail 401 6 channel rec, hs55 servos, like 90 blades
What I did is clip the red wire that plugs into the gyro from the ics 50 is this correct

PM  EMAIL  GALLERY  Attn:RR  Quote
11-05-2004 01:03 PM  13 years agoPost 5
Shanti

rrNovice

Israel

My Posts: All  Forum  Topic

Hi

You should connect as follows

1. Battery <-> Main ESC power
2. Battery <-> Tail ESC power
3. Main ESC <-> Receiver channel 3
4. Aileron servo <-> Receiver channel 1
5. Elevator servo <-> Receiver channel 2
6. Pitch servo <-> Receiver channel 6
7. GY 401 (Rudder) <-> Receiver channel 4
8. GY 401 (Gain) <-> Receiver channel 5
9. GY 401 (Output) <-> Tail ESC

Shanti

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 503 views POST REPLY
HomeAircraftHelicopter
e-
Electric General Discussion
› seperates question 401
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, June 25 - 6:58 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online