RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 453 views POST REPLY
HomeAircraftHelicopterHIROBOOther › Yoke Bolts
11-01-2004 11:28 PM  13 years agoPost 1
helisonlyforeme

rrNovice

Australia

My Posts: All  Forum  Topic

I have a Freya OP, and purchased a set of 4 cx alloy Yoke bolts, the bolts supplied are different lengths where the original button head bolts are the same length, 2 of the bolts are shorter and 2 are longer than the original.
Do the longer ones go on the damper or the bearings?

Also there is a fair bit of in out movement on the stabiliser control arm assembly, probably about .5 mm is this normal or should I fit shims to the middle of the stabiliser control arm where the flybar fits through.

Thanks

PM  EMAIL  Attn:RR  Quote
11-01-2004 11:56 PM  13 years agoPost 2
I3DM

rrProfessor

Israel

My Posts: All  Forum  Topic

i never knew the lengths were different but i would have made sure these are the right ones, and if so, use the longer ones for the dampners.

regardless, CX now uses 1 through bolt (with a locnut) in every hole (2 in total) in the rotor head hub - much better \ fail safe system !

www.liorzahavi.com

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
11-02-2004 03:56 AM  13 years agoPost 3
helisonlyforeme

rrNovice

Australia

My Posts: All  Forum  Topic

Any ideas about the stabiliser control assembly

PM  EMAIL  Attn:RR  Quote
11-02-2004 07:29 AM  13 years agoPost 4
mrNoodles

rrProfessor

Borlänge, Sweden

My Posts: All  Forum  Topic

You can use sandpaper to make the rods (the ones being between the plastic stab. control arms) shorter.
Be careful so you dont remove to much material.

/Fredrik
'Hm now I just have to find out where to connect the GV1 sensor to the Jazz80 ESC.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
11-02-2004 11:56 AM  13 years agoPost 5
z11355

rrMaster

New England

My Posts: All  Forum  Topic

yes, you'll want to take a TINY amount off the
length of those rods.

And...

Make sure you have installed the aluminum
bits inside the plastic end pieces correctly. You
should see the tiny lipped edge.

Also, squeeze the plastic end pieces a bit while
you are tightening down the setscrews that hold
the flybar in place.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 453 views POST REPLY
HomeAircraftHelicopterHIROBOOther › Yoke Bolts
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Wednesday, June 20 - 12:46 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online