RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 740 views
HelicopterEngines Plugs Mufflers Fuel › How to remove a sleeve?
04-29-2002 01:15 AM  15 years agoPost 1
ScotY

rrApprentice

USA

My Posts: All  Forum  Topic

I need to replace the bearings on an OS61WC...got everything out but can't seem to get the sleeve to let go. I've done this before but this one is stuck! Using heat seems logical, but how to get ahold of the sleeve when everything is hot? Any ideas?

PM  EMAIL  GALLERY  Attn:RR  Quote
04-29-2002 02:18 AM  15 years agoPost 2
ScotY

rrApprentice

USA

My Posts: All  Forum  Topic

Thanks David,
That worked so the sleeve is out. I had not taken the piston out yet...that would have required the Dremel. Problem is now getting the damn rod off the crank. The engine is pretty rusty and gunked up so the rod will not slide in the piston enough to get the bottom end off. I probably should just toss this thing.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-29-2002 03:08 AM  15 years agoPost 3
crash-

rrVeteran

Ca

My Posts: All  Forum  Topic

warm up the crank case drop a dime in the cycinder catch
the sleeve with the dime and piston turn the crank easy sleeve
will come out
BURN MORE FUEL

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 740 views
HelicopterEngines Plugs Mufflers Fuel › How to remove a sleeve?
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Tuesday, December 12 - 11:50 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online