RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 689 views
HelicopterClassifieds - Fuel Helicopters Sold  R 60 Tail Rotor assembly; WTB
04-28-2002 05:31 AM  15 years agoPost 1
pileit1

rrNovice

Gastonia, NC

My Posts: All  Forum  Topic

My Classified Activity
No Classified Feedback
Add Classified Feedback

I'm looking for a complete R60 tail rotor assy. Hub, grips, bearings, and blades.

Thanks for looking.
P.S. It doesn't necessarily have to be assembled.

PM  EMAIL  Attn:RR  Quote
04-28-2002 01:15 PM  15 years agoPost 2
HelicopterJohn

rrKey Veteran

Seffner, Florida (Just East of Tampa, Florida)

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Just buy the parts

I believe the total cost should be less than $30.00

The hub is about $5.00, the grips around $6.00, the bearings (4) are around $10.00 and the blades are about $6.00.

I used this setup on my Raptor 50 conversion and it works fine. The only issue is the blades are about 95 mm and I believe they could hit the main blades in a bad landing. You could take a little off the length is this is a problem.

OC Bob's Gathering #2 was a Premiere Event. Pictures in my Gallery

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 689 views
HelicopterClassifieds - Fuel Helicopters Sold  R 60 Tail Rotor assembly; WTB
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Classifieds › HELP-FAQ
Attention buyers! For sellers to Add Classified Feedback you need to Post Reply in the seller’s topic thus creating the green feedback link.
Stating price is not mandatory but recommended. Complaining about price or complaining about pre-sale negotiations is inappropriate and against policy.
Buyer Beware! RunRyder cannot vouch for any seller's or buyer's credibility and will not accept responsibility for any transactions resulting from the use of this site.

Saturday, December 16 - 10:44 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online